|
| |
TM 9-2320-304-14&P
2-82.138
Operating Instructions (Cont)
2-10.9 LOADING/UNLOADING ISO CONTAINER WITH M3 CROP (CONT).
CAUTION
Extreme caution must be used to make
sure bottom CROP rollers remain inside
ISO container. Failure to comply may
result in damage to equipment.
(6)
Move joystick to UNLOAD, allowing truck
to be pushed forward, until front of
CROP (2) is approximately 12 in. (30 cm)
from ground. Proceed to step (10).
(7)
Position ISO container loading
platforms (5) on ground, in front of and
against ISO container door opening so
CROP rollers (3) can roll up container
loading platforms (5) into ISO container.
(8)
Unload CROP (2) until bottom CROP
rollers (3) are grounded in front of ISO
container loading platforms (5) and front
of CROP (2) is approximately 12 to 18 in.
(30 to 46 cm) from ground.
(9)
Using at least one ground guide, use
truck to push CROP (2) up loading
platforms (5) and into ISO container.
CAUTION
Make sure CROPs do not contact top of
ISO container door opening or inside walls
of ISO container. Failure to exercise
extreme caution during insertion may
result in damage to ISO container or
CROP.
(10)
Using at least one ground guide, back
truck up until CROP front twist lock
housings are inside ISO container.
(11)
If CROP appears to be out of alignment
inside ISO container:
(a) Stop truck. Pull truck and CROP
forward several feet. Back up truck
and realign CROP.
(b) After CROP has been properly
realigned, back truck up until CROP
front twist lock housings are inside
ISO container.
Change 1
|
