|
| |
TM 9-2320-304-14&P
2-70
Operating Instructions (Cont)
2-9. LOAD HANDLING SYSTEM (LHS) (CONT).
CAUTION
·
Engine speed must be at idle before using hydraulic selector switch or damage to
equipment may result.
·
Hydraulic selector switch must remain in MAN TRANS position while truck is
traveling or damage to equipment may result.
(17) Turn hydraulic selector switch (7) to MAN TRANS position.
(18) Put PTO ENGAGE switch (5) in OFF position. Make sure indicator light (6) goes off.
NOTE
If load locks do not engage, raise flatrack slightly and lower again. Flatrack should seat
completely and engage load locks.
(19) Inspect that load locks (16) are engaged and flatrack is fully loaded on truck.
|
