Assemble the Oil Pump, Filter, and Cover

TM 9-2320-303-24-2

FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED

0257 00

DIFFERENTIAL CARRIER ASSEMBLY - CONTINUED

CAUTION

Do not exert pressure on the seal retainer after it bottoms. Damage to the seal will result.

(4)

If the front oil seal was removed, install a new seal into the front of the bearing cage. Coat the sealing lip

with oil (Item 33, WP 0312 00) and outer diameter of retainer with a non-hardening sealing material, such

as compound (Item 14, WP 0312 00). Use a press or arbor and suitable sleeve and press seal into position

until it bottoms in the bearing cage.

(5)

When the original input shaft forward bearing is reused, assemble the original shim pack and bearing cage

with the bearing cup onto the gear cover. Secure the cage with capscrews and washers. Torque to 35-50 lb-

ft (47-68 Nm).

(6)

If a new bearing is used, assemble the bearing cage with a new cup over the helical gear cover. Do not

install a shim pack. Assemble and tighten the capscrews and washers to finger-tight while rotating the

shaft to seat bearings.

Assemble the Oil Pump, Filter, and Cover.

(1)

Assemble the oil pump relief valve cover (26) by inserting ball (30), spring (small diameter against ball)

(31), and hollow capscrew (32). Torque capscrew to 40-55 lb-ft (54-75 Nm).

402-656

0257 00-41