REPAIR OR REPLACEMENT - CONTINUED - TM-9-2320-303-24-20229

TM 9-2320-303-24-2

FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED

0257 00

REPAIR OR REPLACEMENT - CONTINUED

(8)

Position the driver and sleeve bushing into the tool cavity, tapered end first.

(9)

Place the driver and sleeve bushing squarely against the hub end of the yoke.

CAUTION

Do not install the sleeve bushing by striking the driver, as this practice may cause excessive expansion of the

sleeve bushing and will permit the sleeve bushing to rotate on the yoke.

(10)

Employing a small mechanical press, place the driver, sleeve bushing and yoke into the press.

PRESS

SLEEVE BUSHING

DRIVER

INSIDE DRIVER

CAVITY

O-RING

HUB END

OF YOKE

YOKE

SUPPORT

YOKE

PRESS

SUPPORT

402-668

(11)

Activate the press, forcing the driver to push the sleeve bushing onto the yoke until it bottoms.

O-RING

SLEEVE

BUSHING

SLEEVE BUSHING

1/16" REF

TOOL

YOKE

402-669

INPUT YOKE

OUTPUT YOKE

(12)

When removing the driver, pull the driver straight off. Do not work the driver in a circular or alternately

back-and-forth motion, as this may damage the sleeve bushing surface.

(13)

Examine the sleeve bushing after installation for nicks or burrs that may cut or wear the seal. These may be

removed by careful filing.

0257 00-21