Remove Input Shaft, Forward Bearing, and Shift Collar

TM 9-2320-303-24-2

FORWARD-REAR AXLE DIFFERENTIAL CARRIER REPAIR - CONTINUED

0257 00

DIFFERENTIAL CARRIER DISASSEMBLY - CONTINUED

Remove Input Shaft, Forward Bearing, and Shift Collar.

NOTE

To remove the interaxle differential shift collar, it is necessary to disassemble the input shaft from the gear

cover. Use the following procedure.

(1)

Remove the input yoke nut and washer from the input shaft (33).

CAUTION

If the input oil seal is not to be serviced, care must be taken when pulling the yoke so as not to damage the

seal in the bearing. Do not use a hammer to loosen yoke. This will damage the yoke and splines and cause

excessive yoke run out and misalignment.

(2)

Remove the input yoke (15) from the input shaft (33) using a yoke puller.

YOKE PULLER

35,36

402-657

0257 00-8