 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-2
FRONT AXLE CASTER ADJUSTMENT - CONTINUED
0250 00
ADJUSTMENT - CONTINUED
WARNING
Before removing shim(s), ensure vehicle is properly supported to prevent possible injury to personnel.
3.
Raise spring (2) high enough from axle (5) to allow removal of shim(s) (7).
4.
Remove spacer (8), shim(s) (7), and dowel (6).
5.
Install dowel (6) in axle (5).
WARNING
If more than one shim is to be added, shims must be welded together prior to installation. Failure to do so
may cause shim slippage resulting in equipment damage and/or injury to personnel.
NOTE
Install shims with tapered end toward front of vehicle.
6.
Install new shim(s) (7) to obtain +3.5 to +6.5 degrees of caster angle.
1
2
8
7
6
3
4
5
NOTE
Ensure dowel protrudes through shim(s) enough to hold spacer in place. If dowel does not protrude into
spacer, replace dowel.
7.
Install spacer (8).
8.
Lower spring (2) onto axle (5).
9.
Coat threads of two U-bolts (1) with antiseize compound.
10.
Install four washers (3) and nuts (4) on two U-bolts (1). Tighten nuts to 380-460 lb-ft (515-624 Nm).
END OF WORK PACKAGE
0250 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals