 |
|||
|
|
|||
|
Page Title:
Installation of Output Shaft and Oil Seal |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-2
TRANSMISSION OVERHAUL - CONTINUED
0248 00
ASSEMBLY - CONTINUED
Installation of Output Shaft and Oil Seal
1.
Install new oil seal (7) in rear cover.
2.
Install output yoke (8) and new O-ring (9).
3.
Insert bolt (12) through retainer plug (11). Install a new O-ring (10) on bolt so that O-ring seats against retainer plug.
4.
Install retainer plug (11) into yoke (8). Tighten bolt (12) to 38-45 lb-ft (51-61 Nm).
7
8
9
10 11
12
5.
Install engine, turbine, and output speed sensors (WP 0112 00).
TABULATED DATA
Table 1. Torque Converter Selective Shims.
Dimension C
Use P/N
Shim Thickness (Ref.)
ID No.
0.4129-0.6598 mm (0.0163-0.0259 in)
29505688
4.000 mm (0.157 in)
0
0.6597-0.8378 mm (0.0260-0.0329 in)
29505681
4.203 mm (0.165 in)
1
0.8379-1.0158 mm (0.0330-0.0399 in)
29505682
4.381 mm (0.172 in)
2
1.0104-1.1938 mm (0.0400-0.0469 in)
29505683
4.559 mm (0.179 in)
3
1.1939-1.3708 mm (0.0470-0.0539 in)
29505684
4.736 mm (0.186 in)
4
1.3709-1.5488 mm (0.0540-0.0609 in)
29505685
4.914 mm (0.193 in)
5
1.5489-1.7268 mm (0.0610-0.0679 in)
29505686
5.092 mm(0.200 in)
6
1.7269-1.9048 mm (0.0680-0.0749 in)
29507793
5.230 mm (0.207 in)
7
1.9049-1.9733 mm (0.0750-0.0776 in)
29507794
5.448 mm (0.214 in)
8
0248 00-58
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals