Rotating Clutch Module Disassembly - Continued

TM 9-2320-303-24-2

TRANSMISSION OVERHAUL - CONTINUED

0248 00

MODULE OVERHAUL - CONTINUED

Rotating Clutch Module Disassembly - Continued

17.

Lift rotating drum (24) from clutch hub (6) and C1/C2 pistons (29 and 35). Inspect clutch splines of rotating drum. Max-

imum spline wear allowed is 0.015 in (0.38 mm).

18.

Remove C1/C2 pistons (29 and 35) and seal rings (28 and 36) from clutch hub (6), by rocking pistons from side to side.

19.

Inspect and measure ID of rotating clutch hub housing bushing (25). Maximum allowable ID of bushing is 4.735 in

(120.27 mm). Remove bushing from clutch hub (6) if replacement is necessary. Avoid damaging bushing bore.

20.

Remove piston seal rings (26 and 27) from clutch hub (6).

21.

Separate C1 piston (35) and seal ring (36) from C2 piston (29) and seal ring (28) by lightly tapping on C1 piston.

0248 00-25