 |
|||
|
|
|||
|
Page Title:
INTER-AXLE DRIVELINE U-JOINTS INSTALLATION |
|
||
| ||||||||||
|
|
 TM 9-2320-303-24-1
DRIVELINE U-JOINTS AND BEARINGS REPLACEMENT - CONTINUED
0117 00
INTER-AXLE DRIVELINE U-JOINTS INSTALLATION
NOTE
Perform the following steps at rear end of inter-axle driveline.
1.
Install two grease fittings (11) on universal joint (12).
2.
Position universal joint (12) and two bearing caps (14) on inter-axle driveline (3).
3.
Install two new screws (13) on each of two bearings caps (14). Tighten screws to 36 lb-ft (49 Nm).
4.
Lubricate universal joint (12) (WP 0024 00).
5.
Install grease fitting (8) on yoke (2).
NOTE
Align matchmarks on each half of inter-axle driveline.
6.
Install dust seal (9) and yoke (2) on inter-axle driveline (3). Tighten dust seal.
NOTE
Perform the following steps at front end of inter-axle driveline.
7.
Install two grease fittings (7) to universal joint (6).
8.
Position universal joint (6) and two bearing caps (5) on yoke (2) of inter-axle driveline (3).
9.
Install two screws (4) on each of two bearing caps (5). Tighten screws to 36 lb-ft (19 Nm).
10.
Lubricate yoke (2) and universal joint (6) (WP 0024 00).
11.
Install inter-axle driveline (WP 0116 00).
10
11
12
3
10
9
2
8
1
13
14
4
7
5
6
1
END OF WORK PACKAGE
0117 00-4
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals