 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-303-24-1
WATER PUMP MAINTENANCE - CONTINUED
0052 00
REMOVAL
1.
Remove adjusting screw (7).
2.
Remove hex nut (8) and lockwasher (9) and remove idler pulley (10) from water pump (11). Discard lockwasher.
3.
Loosen and remove two capscrews (4) and washers (5).
4.
Loosen and remove four capscrews and washers (6).
5.
Loosen and remove two capscrews and washers (12).
6.
Unscrew and remove capscrew (2), lockwasher (1), and clamp (14). Discard lockwasher.
7.
Unscrew and remove four capscrews and washers (13).
8.
Remove water pump (11) and gasket from engine and bypass tube (3). Discard gasket.
INSTALLATION
1.
Put water pump (11) and new gasket in position on engine block and connect bypass tube (3).
NOTE
Install capscrews hand-tight first.
2.
Install and tighten four capscrews and washers (13) to 35 lb-ft (47 Nm).
3.
Install and tighten four capscrews (2), new lockwasher (1), and clamp (14).
4.
Install and tighten two capscrews and washers (12), four capscrews and washers (6) to 35 lb-ft (47 Nm).
5.
Install and tighten two capscrews (4) and washers (5).
6.
Install idler pulley (10) on water pump (11) and secure with hex nut (8) and new lockwasher (9). Do not tighten.
7.
Install adjusting screw (7).
3
4
5
2
6
7
1
8
9
10
14
13
12
402-207
11
0052 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals