 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
STARTER REPLACEMENT (M915A3 OLD MODEL) - CONTINUED
0067 00
NOTE
Tag all cable and wires to ensure correct installation.
REMOVAL
1.
Remove nut (4), washer (3), and cable (2), from threaded stud (1).
2.
Remove nut (18), washer (19), cable (5), and three wires (6) from starter (9).
3.
Remove nut (15), washer (16), and wire (17) from starter (9).
4.
Remove nut (11), washer (12), cable (13), ground strap (14), and two wires (10) from starter (9).
5.
While supporting starter (9), remove three screws (8). Remove starter from engine flywheel housing (7).
6
3
4
2
1
5
7
19
18
17
16
15
8
14
13
12
9
11
10
342-116
INSTALLATION
1.
While supporting starter (9), install starter on engine flywheel housing (7) with three screws (8). Do not fully tighten
screws.
NOTE
For aluminum flywheel housings, tighten screws to 138-154 lb-ft (187-209 Nm). For cast iron flywheel
housings, tighten screws to 181-226 lb-ft (245-306 Nm).
2.
Tighten three screws (8).
3.
Install two wires (10), ground strap (14), cable (13), washer (12), and nut (11) on starter (9). Tighten nut to 20-25 lb-ft
(27-34 Nm).
0067 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals