 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-302-20-2
ALTERNATOR BELT REPLACEMENT AND ADJUSTMENT (M915A3 OLD MODEL) - CONTINUED
0062 00
INSTALLATION
1.
Position drive belt (3) on alternator pulley (7), air conditioning compressor pulley (2), and accessory drive pulley (4).
2.
Install cap screw (9) if removed. If not, proceed to step 3.
3.
Tighten drive belt tension by loosening hex nut (8) and tightening hex nut (11) on adjusting rod (12) and link (10) until
drive belt is tight. Tighten hex nut (8).
4.
Tighten three cap screws (1, 5, and 9) to 60-70 ft-lb (81-95 Nm).
ADJUSTMENT
1.
Back off hex nut (8) and tighten hex nut (11) until belt free-play is less than 1/2 inch.
2.
Start engine (TM 9-2320-302-10) and operate engine for 30 minutes (or 15 miles).
3.
Check belt tension and adjust as required. Recheck belt tension again after 8 hours of operation and adjust as required.
2
1
12
11
10
9
8
3
7
4
6
5
END OF WORK PACKAGE
0062 00-2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals