PUSHER AXLE WILL NOT MAINTAIN LOAD REACTION.

TM 9-2320-273-10

Table 3-1. Troubleshooting-Continued

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

28. PUSHER AXLE WILL NOT MAINTAIN LOAD REACTION.

Step 1. Check to make sure that air system pressure is sufficient (low air

pressure warning light and buzzer are both off).

Let air pressure build up until warning light and buzzer go off.

Step 2. Check to make sure that air control pressure adjuster is turned fully to

the right.

Turn air control pressure adjuster fully to the right.

Step 3. Check for air leaks in the area of hoses and check for cracks or holes in

the air bags.

Notify Organizational Maintenance.

PTO

29. PTO DOES NOT ENGAGE.

Check to make sure that PTO control is in the ENGAGE position reference

1100 rpm and shift cycle.

Move PTO control to the ENGAGE position. If PTO still does

not engage, notify Organizational Maintenance.

NOTE: MAKE SURE that cable is connected to the PTO in case it becomes

loose from road vibrations.

30. PTO INDICATOR LIGHT STAYS ON EVEN THOUGH THE PTO CONTROL KNOB

IS PUSHED COMPLETELY IN.

Check the throttle control on the winch control console to determine that it

has been pushed down.

Push the winch throttle control all the way down.