|
| |
OPERATING WINCHES – CONTINUED
Operating NO. 1 WINCH
TM 9-2320-270-10
1.
2.
3.
NOTE
Engine may be shut down to stop winching operation if necessary by using engine
shutdown control (10). See page 2-92.
Pull engine throttle control (7) as far beck as it will go (toward cab). Main transmission
will shift through its 2 to 5 range.
Check instrument panel tachograph (11) after final upshift. Engine speed should stabilize
at about 2200 rpm.
Move NO. 1 WINCH low speed lever (12) forward to pay out cable and backward to take
up cable at low speed.
CAUTION
Never operate a winch at high speed when there is a load on the winch cable. High
speed is intended for no-load operation only. Failure to follow this caution can
result in equipment damage.
4. For high speed operation, move high speed lever (13) and low speed lever (12) at the same
time and in the same direction. Move both levers forward to pay out cable and backward
to take up cable at high speed.
2-95
|
