LEGEND FOR TRACTOR LUBRICATION CHART

TM 55-1740-200-14

ENGINE GENERATOR (2 OIL CAPS) (SEE NOTE 5)

ENGINE WATER PUMP

ENGINE AIR CLEANER (SEE NOTE 3)

SPRING SHACKLES (4 FITTINGS)

ENGINE CRANKCASE BREATHER (SEE NOTE 3)

RADIAL BEARING (8 UNITS)

STUB (8 FITTINGS)

SPRING ANCHOR (2 FITTINGS)

HAND BRAKE PIVOT, FRONT

HAND BRAKE PIVOT, REAR

TRANSMISSION (SEE NOTE 9)

UNIVERSAL JOINT, TRANSMISSION TO TRANSFER CASE (2 FIT TINGS)

TRANSFER CASE (SEE NOTE 8)

TRANSFER CASE BREATHER (SEE NOTE 3)

UNIVERSAL JOINTS AND DRIVE SHAFTS (TRANSFER CASE TO DIFFERENTIALS)

(6 FITTINGS)

SPRING ANCHOR (2 FITTINGS)

AXLE HOUSING BREATHERS (2) (SEE NOTE 3)

DIFFERENTIALS (2) (SEE NOTE 9)

PINTLE HOOKS (4 FITTINGS)

SPRING SHACKLES (4 FITTINGS)

CYLINDER ROD END

STEERING ARMS (4 FITTINGS)

VACUUM BRAKE BOOSTER TANK BREATHER (SEE NOTE 3)

CYLINDER ROD END

TRANSMISSION BREATHER (SEE NOTE 3)

REAR STEER CAM PIVOT

REAR STEER CAM LINKAGE

CYLINDER ROD ENDS (2 FITTINGS)

BELLCRANK

THE ROD END

CYLINDER ROD END

STEERING GEAR (SEE NOTE 9)

TIE ROD END

TORQUE CONVERTER OIL FILTER (SEE NOTE 4)

ENGINE OIL FILTER (SEE NOTE 4)

HYDRAULIC RESERVOIR (SEE NOTE 7)

HYDRAULIC RESERVOIR BREATHER CAP (SEE NOTE 3)

DISTRIBUTOR (SEE NOTE 5)

ENGINE OIL FILLER CAP (SEE NOTE 3)

ENGINE CRANKCASE (SEE NOTE 6)

LUBRICATION NOTES

GENERAL

1. CLEAN FITTINGS, BEFORE LUBRICATING, WITH DRYCLEANING SOLVENT, FEDERAL

SPECIFICATION P-S-661. DRY BEFORE LUBRICATING.

2. IF CLIMATE OR OPERATING CONDITIONS REQUIRE EQUIPMENT TO BE LUBRICATED

OFTEN TO PREVENT WEAR AND DETERIORATION, THE MAINTENANCE OFFICER WILL

TAKE REMEDIAL ACTION AS REQUIRED.

TRACTOR

REMOVE, CLEAN AND OIL EACH INTERMEDIATE INSPECTION.

CHANGE FILTER ELEMENTS AND CLEAN FILTERS EACH INTERMEDIATE INSPECTION.

TWO DROPS OF OIL EACH QUARTERLY INSPECTION.

CHANGE OIL EACH INTERMEDIATE INSPECTION.

CHECK OIL DAILY AND CHANGE ANNUALLY.

CHANGE OIL ANNUALLY.

SEASONAL CHANGE AS REQUIRED.

AV 008864

Figure 3-5. Tractor lubrication chart (Sheet 2 of 3)

3-10