REPAIR-continued -714670530

5-2420-224-34

CYLINDER BLOCK REPAIR (CONT)

CAUTION

M a k e sure all machining residue is removed before assembling engine. Failure

to do so could result in increased engine wear and reduced service life of

engine.

10.

Clean cylinder block thoroughly with soap and water. Dry cylinder bores immediately after cleaning and

apply light coat of lubricating oil.

If top of engine requires machining, remove only amount of material necessary to obtain measurements

11.

of next repair stage shown on page 13-53.

If dfferent size tappet is to be installed upon assembly of engine, bore tappet holes in cylinder block

12.

so that clearance between tappet and engine bled bore is 0.004-0.0020 in. (0.10-0.053 mm).

13-55