 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2420-224-34
REAR AXLE ASSEMBLY REPLACEMENT (CONT)
10. PLACE rear AXLE assembly
(2)
on
transmission JACK or equivalent.
11. INSTALL new PACKING (13).
INSTALL
HOUSING (2.1).
CAUTION
Support axle torque tube prior to
installing rear axle assembly to
prevent damage to equipment.
12. WITH VEHICLE on suitable jack STANDS,
RAISE VEHICLE and PLACE rear AXLE
assembly (2) in position.
CAUTION
Make sure slots are aligned in
shaft and transmission during
installation to prevent damage to
equipment.
13. APPLY
COAT
of
MOLYBDENUM
DISULFIDE GREASE to propeller shaft
FLANGE (14) and ALINE propeller shaft
FLANGE (14) with transmission output
FLANGE (15).
14. APPLY COAT of SEALING COMPOUND to
six SCREWS (16). INSTALL six SCREWS
(16) and TIGHTEN to 42 lb-ft (56 N.m).
15. INSTALL two HOUSINGS (17), four new lock
washers (18), and four nuts (19). TIGHTEN
NUTS hand-tight.
16. APPLY COAT of SEALING COMPOUND to
six SCREWS (20). INSTALL six SCREWS
(20) and six new spring tension washers (21)
until SNUG.
17. TIGHTEN four NUTS (19) to 45 lb-ft (60
N.m).
18. TIGHTEN six SCREWS (20) to 42 lb-ft (56
N.m).
19. INSTALL BELLOWS (22) and clamps (23
and 24). TIGHTEN two SCREWS (25).
20. INSTALL vent HOSE (26) in bellows (22).
21. INSTALL BRACKET (27), screw (28), and
washer (29).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals