 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2420-224-34
Table 2-1. Troubleshooting (Cont)
Malfunction
Test or Inspection
Corrective Action
STEERING SYSTEM (CONT)
Step 2. Check steering knuckle for binding or excessive tightness as follows:
a. Remove tie rod and drag link (TM 5-2420-224-20).
b. Raise vehicle enough to clear wheel from ground.
Move wheel fully left and right and check for free and smooth movement
c.
with no binding.
If wheel binds or does not move freely, replace steering
knuckle (page 5-16).
If wheel does not bind and moves freely, replace power
steering gear (page 7-11).
HYDRAULIC SYSTEM
NOTE
Perform step 1 for front hydraulic pump. Perform step 2 for rear hydraulic pump.
Step 1. Check front loader/forkIift relief valve pressure as follows:
a. Park vehicle on level surface and set parking brake.
b. Open front loader/forklift travel lock valves.
Leave front loader/forklift in transport position.
c.
d. Remove cap (1) from fitting in inlet (2) of front loader/forklift control
valve (3) located behind cab.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals