Table 3-5. Troubleshooting (Cont)
Test or Inspection
ELECTRiIAL SYSTEM (CONT)
79. TRANSMISSION WILL NOT OPERATE IN ANY FORWARD OR REVERSE GEAR.
Check clutch slave cylinder for proper adjustment as follows:
a. Remove return spring (1) from slave cylinder (2) and clutch lever (3).
b. Loosen lock nut (4) and back out adjusting screw (5) completely.
Move clutch lever (3) down until it stops. Clearance between clutch lever
(3) and adjusting screw (5) must be 1/8 in. (3 +0.05 mm).
If clutch slave cylinder is not property adjusted, adjust clutch
slave cylinder (page 4-21).
If clutch slave cylinder is property adjusted, notify direct support