|
|
![]() TM
5-2420-224-20-1
Table 3-5. Troubleshooting (Cont)
Malfunction
Test or Inspection
Corrective Action
ELECTRICAL SYSTEM (CONT)
36. DOME LIGHT WILL NOT LIGHT.
NOTE
· Vehicle MASTER disconnect switch must be ON and master light switch set to SER
DRIVE. Failure to do so will cause erroneous results.
· Refer to wiring diagram (page 3-132) for all wiring repair steps.
Remove dome light (1) and check for +24 VDC between wire 43 (2) and ground at
dome light.
· If +24 VDC is present, replace two lamps (3).
· If +24 VDC is not present, repair wiring 43 between dome light
and fuse box 1.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |