After Starting the Engine.

TM 5-2420-224-10

(3)

Position slave vehicle so that slave receptacles (1) are adjacent.

(4)

Make sure master disconnect switch, ignition switch, and all accessory switches in receiving vehicle

are OFF.

(5)

Start engine in slave vehicle and run engine at 1000 to 1200 rpm.

(6)

Remove cap from slave receptacle (1) and connect slave cable (2).

(7)

Start engine in receiving vehicle (page 2-75). If engine does not start, troubleshoot (refer to page

(8)

Disconnect slave cable (2) and install cap on slave receptacle (1).

e. After Starting the Engine.

(1)

Operate engine at low idle (700-750 rpm) until hydraulic oil is warm. When temperature is below

35F (2C), engage PTO and move all hydraulic controls slowly to help warm oil and control. Move

each cylinder several times to warm it.

(2)

Test hydraulic controls. Allow extra warm up time if controls are sluggish.

Change 1

2-77