INSTRUMENT PANEL (Cont) - TM-5-2420-224-100041

TM 5-2420-224-10

(10)

Auxiliary Headlight Switch (10). Two-position switch. Vehicular light switch must be on to operate auxiliary

headlight switch. Position auxiliary headlight switch (10) up to operate auxiliary lights; down to operate service

lights.

CAUTION

Do not catch hood on brake fluid reservoir and windshield washer reservoir when

removing hood with front loader installed. To do so could result in equipment damage.

(a)

Remove key from left-hand door box (11) to open hood (12).

(b)

To remove engine hood (12), unlock at bottom (13) and at upper bore (14).

Lift hood slightly from below and release safety latch on left side by reaching inside bottom-left corner.

(c)

Remove engine hood (12).

WARNING

SEE only: When in transport position, use auxiliary headlights instead of vehicle

headlights; during operation vehicle headlights are blocked by bucket. HMMH only: Use

auxiliary headlights when using forklift with a load that blocks vehicle headlights. Failure

to do so could result in personnel injury.

(d)

Open hood (12) to gain access to the auxiliary headlight switch.

2-7