|
| |
TM 5-2420-222-34
13-6
FENDERS AND SUPPORTS MAINTENANCE (Con’t).
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only In a well-ventilated area. Avoid contact with
skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open
flame or excessive heat. The solvent's flash point Is 100°F-138°F (38°C-59°C). If
you become dizzy while using cleaning solvent, Immediately get fresh air and
medical help. If solvent contacts eyes, Immediately wash your eyes and get
medical aid.
CAUTION
Do not remove liner section unless damaged. Removal may damage liner section.
NOTE
Step 8 applies only to loader backhoes with serial numbers 319995-342573
8.
Lift up comer of liner section (49) and dissolve adhesive
with rags and dry cleaning solvent. Continue to wet with
dry cleaning solvent until liner section is completely off
fender (1).
9.
Clean adhesive off fender (1) with dry cleaning solvent
and clean rags. Rinse with clean water and dry
thoroughly.
c.
CLEANING AND INSPECTION
1.
Clean fender and assembled parts with rag dampened in water and detergent solution. Rinse with clean water and dry
thoroughly.
WARNING
Dry cleaning solvent, P-D-680, is toxic and flammable. Always wear protective
goggles and gloves, and use only in a well-ventilated area. Avoid contact with
skin, eyes, and clothes, and DO NOT breathe vapors. DO NOT use near open
flame or excessive heat. The solvent's flash point Is 100°F-138°F (38°C-59°C). If
you become dizzy while using cleaning solvent, Immediately get fresh air and
medical help. If solvent contacts eyes, Immediately wash your eyes and get
medical aid.
2.
Clean all other metal parts with dry cleaning solvent and rags. Dry thoroughly with clean, dry rags.
3.
Inspect all metal parts for cracks, breaks, and abnormal bends.
TA701535
13-38
|
