|
| |
TM 5-2420-222-34
13-6
FENDERS AND SUPPORTS MAINTENANCE.
This Task Covers:
a.
Removal
d.
Assembly
b.
Disassembly
e.
Installation
c.
Cleaning and Inspection
Initial Setup:
Equipment Conditions:
Materials/Parts:
•
Combined tail and stoplight removed (see TM 5-
•
Metal bonding adhesive (Item 1, Appendix B)
2420-222-20).
•
Detergent (Item 13, Appendix B)
•
Combined tail and floodlight removed (see TM 5-
•
Rags (Item 28, Appendix B)
2420-222-20).
•
Dry cleaning solvent (Item 31, Appendix B)
•
Loader backhoe control guards removed (see TM 5-
•
Lacing and tying tape (Item 37, Appendix B)
2420-222-20).
•
One special nut
•
Rear light wiring harness removed (see TM 5-2420-
•
Twenty-six lockwashers
222-200
•
Twenty-six lockwashers
•
Stoplight wiring harness removed (see TM 5-2420-
•
Electrical tie-down straps (as required)
222-20).
Tools/Test Equipment:
•
General mechanic's tool kit
NOTE
•
Field automotive shop set
Perform the following only If removing right
fender.
•
Center platform removed (see TM 5-2420-222-20).
Personnel Required:
Two
•
Loader backhoe control box door removed (see
TM 5-2420-222-20).
General Safety Instructions:
•
Dry cleaning solvent is flammable and must not be
used near open flame. Use only in a well-ventilated
NOTE
area.
Perform the following only if removing left
fender.
•
Warning alarm wiring harness removed (see TM 5-
2420-222-20).
NOTE
Both fenders and supports are maintained the same way. Left side is shown.
Repeat procedure for right side unless otherwise noted.
13-32
|
