|
| |
TM5-2420-222-34
13-1.
ROLL-OVER PROTECTIVE STRUCTURE OR CANOPY FRONT MOUNTS AND BRACKETS MAINTENANCE
(Con’t).
NOTE
• Loader backhoes with serial numbers 235786-235999 have a canopy. Loader
backhoes with serial numbers 319995-342573 have a roll-over protective
structure (ROPS).
• Both front mounts and brackets for canopy or ROPS are maintained the same way. Left side Is
shown. Repeat procedure for right side as required.
a.
REMOVAL
WARNING
Use extreme caution when handling heavy parts. Lifting device is required when
parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two
person lift, and over 150 lb (68 kg) for a three or more person lift. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may
cause serious Injury or death to personnel.
1.
Using lifting device, support canopy or ROPS (4).
2.
Remove four screws (7), washers (6), lockwashers (5), and front crossmember (3) from canopy or ROPS (4).
Discard lockwashers.
NOTE
If removing right front mounts and special bracket, skip step 3.
3.
Remove screw 1), two clamps (12), hydraulic lines (2), spacer (11), lockwasher (10), and nut (9) from special
bracket weldment (8). Discard lockwasher.
TA701508
13-2
|
