|
| |
TM 5-2420-222-34
11-3.
STEERING VALVE ASSEMBLY MAINTENANCE.
14.
Position plate spacer (19) on valve housing (8) with holes alined.
NOTE
Step 15 applies only to loader backhoes with serial numbers 319995-342573.
15.
Coat two new preformed packings (23) with hydraulic fluid and install on valve housing (8).
16.
Position outer gear (17) in place on plate spacer (19) and valve housing (8) with holes alined.
17.
Install drive shaft (21) in valve housing (8) with slotted end of drive shaft seated over centering straight pin (12).
18.
Install inner gear (18) on drive shaft (21) and in outer gear (17). Valley in inner gear must be alined with centering
straight pin (12).
19.
Install sleeve spacer (20) on drive shaft (21) in inner gear (18).
NOTE
Step 20 applies only to loader backhoes with serial numbers 319995-342573.
20.
Coat new preformed packing (23) with hydraulic fluid and install on outer gear (17).
21.
Position cover (16) in place on outer gear (17) and valve housing (8) and secure with seven bolts (15). Torque
bolts to 250 lb.-in. (28.3 N•m).
FOLLOW-ON TASKS:
•
Install steering column and valve support (see paragraph 11-1).
TA701490
11-23/(11-24 Blank)
|
