TM 5-2420-222-34 Section II.  REAR AXLE MAINTENANCE 9-3. REAR AXLE HOUSING, SHAFTS, SEALS, BEARINGS, AND PLANETARY PINION CARRIER MAINTENANCE. This Task Covers: a. Removal                                                     d.    Repair b. Disassembly    ‘ e. Assembly c. Cleaning and Inspection f. Installation Initial Setup: Equipment Conditions: Materials/Parts: • Roll-over protective structure or canopy rear mounts • Grease (Item 22, Appendix B) removed (see paragraph 13-4). • Rags (Item 28, Appendix B) NOTE • Tin alloy solder (Item 30, Appendix B) • Dry cleaning solvent (Item 31, Appendix B) Perform the following only If removing left rear • Marker tags (Item 32 , Appendix B) axle housing. • Marker tags (Item 32, Appendix B) • Pressure sensitive tape (Item 38, Appendix B) • Battery tray removed (see TM 5-2420-222-20). • One gasket NOTE • One grease fitting • One plain encased seal Perform the following only If removing right • Two 9/16 in. -12 UNC x 5 in. screws (serial numbers rear axle housing. 235786-235999) • Battery ground cable disconnected (see TM 5-2420- • Two 3/4 in.-10 UNC x 5 in. screws (serial numbers 222-20). 319995-342573) • Parking brake lever support removed (see • Five preformed packings TM 5-2420- 222-20). • Shims (as required) • Loader control valve and mounting bracket removed (see TM 5-2420-222-20). Personnel Required: Two • Jaw control valve and mounting bracket removed (see TM 5-2420-222-20). General Safety Instructions: Tools/Test Equipment: • Dry cleaning solvent is flammable and must not be used near open flame.  Use only in a well-ventilated • General mechanic's tool kit area. • Field automotive shop set • Hot oil gives off highly flammable fumes and must not be used near open flame. References: • TM 5-2420-222-20 • TM 9-214 NOTE Left and right rear axle housings, shafts, seals, bearings, and final drive planetary pinions are maintained the same  way, except as noted.  Repeat steps as required for other side. 9-10