|
| |
TM 5-2420-222-34
8-16.
REVERSER HOUSING MAINTENANCE (Con’t).
10.
Install reverser clutch drum and disk (12) as an assembly in reverser housing (1).
11.
Install clutch disk carrier or clutch support bearing carrier (see paragraph 4-4).
e.
INSTALLATION
WARNING
Use extreme caution when handling heavy parts. Lifting device Is required when
parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two
person lift, and over 150 lb (68 kg) for a three or more person lift. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may
cause serious Injury or death to personnel.
1.
Use lifting device to aline reverser housing (1) with transmission (8).
2.
Install new gasket (9) on reverser housing (1).
3.
Aline mounting holes of reverser housing (1) with holes in transmission (8).
4.
Install two screws (2) and washers (3). Do not tighten.
5.
Install screw (11) and washer (10). Do not tighten.
6.
Install six screws (6), washers (7), two screws (5), and washers (4).
7.
Tighten screw (11) and two screws (2).
8.
Remove lifting device.
TA701402
8-70
|
