|
| |
TM 5-2420-222-34
8-2.
TRANSMISSION MAINTENANCE (Con’t).
NOTE
Transmission has two rear axle housings. Installation of rear axle housings is the
same. Left side is shown. Repeat steps 2 through 7 as required for right side.
2.
Remove brake disk (39) and brake pressure plate (40) from rear axle housing (5).
3.
Apply coat of grease to brake pressure plate (40), then position back in rear axle housing (5).
WARNING
Use extreme caution when handling heavy parts. Lifting device is required when
parts weigh over 50 lb (23 kg) for a single person lift, over 100 lb (45 kg) for a two
person lift, and over 150 lb (68 kg) for a three or more person lift. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may
cause serious injury or death to personnel.
5.
Using lifting device and the aid of an assistant, lift and position rear axle housing (5) and new gasket (15) in place
against transmission (6) with screw holes alined.
6.
Install 12 screws (14) in transmission (6) and rear axle housing (5). Torque screws alternately to 85 lb.-ft. (115
N•m).
7.
Support rear axle housing (5) with wood blocks and remove lifting device.
CAUTION
When installing transmission, ensure that all loose parts are clear or parts may be damaged.
8.
Install two lifting eyes (3) in upper holes (4) of reverser housing (2).
TA701365
8-14
|
