|
| |
TM 5-2420-222-34
7-2.
ENGINE STARTER REPAIR (Con’t).
NOTE
• If old sleeve bushing was removed and is being reinstalled in electrical end bell,
perform steps 8 and 9, then proceed to step 12.
• If new sleeve bushing is being installed, skip step 8.
8.
If old sleeve bushing (55) is being reinstalled, line up oil holes in sleeve bushing and electrical end bell (5).
9.
Using arbor press and X in. outside diameter remover and installer, press sleeve bushing (55) in electrical end bell
(5).
10.
Using electric drill and twist drill set, drill hole in sleeve bushing (55) through oil wick hole using same size twist drill
as oil wick hole.
11.
After drilling new sleeve bushing (55), ream hole to 0.5625-0.5635 in. (14.2875-14.3129 mm) and remove burrs
using hand reamer set.
12.
Apply light coat of engine oil to sleeve bushing (55).
13.
Soak wick end (46) in engine oil. Install wick end in electrical end bell (5).
NOTE
Some loader backhoes do not have second wick and pipe plug.
14.
Soak wick (57) in engine oil. Position wick in electrical end bell (5) and install pipe plug (56).
NOTE
If supports and leads were not removed, skip steps 15 and 16.
15.
Position two supports (30) and leads (29) in place inside main housing (2).
16.
Install four screws (47), new lockwashers (53), and nuts (54) in main housing (2), two supports (30), and leads
(29).
TA701351
7-23
|
