|
| |
TM 5-2420-222-34
4-2.
CLUTCH ASSEMBLY MAINTENANCE (SERIAL NUMBERS 319995-342573). (Con’t)
3.
Install pilot ball bearing (2) in flywheel (1).
4.
Position clutch alining tool in place on pilot ball bearing (2). Install clutch disk (3) on clutch alining tool and against
flywheel driving surface. Ensure that long end of clutch disk faces away from flywheel (1).
5.
Install clutch disk (4) on clutch alining tool, clutch disk (3), and flywheel (1). Install six screws (5) and new lockwashers
(6), one at a time, until spring tension is felt. Tighten each screw one turn, then repeat until all six screws are tight.
6.
Torque six screws (5) to 25 lb.-ft. (34 N•m). Remove clutch alining tool.
FOLLOW-ON TASKS:
•
Install engine assembly (see paragraph 3-3).
•
Adjust clutch pedal linkage (see TM 5-2420-222-20).
4-14
|
