|
| |
TM 5-2420-222-34
4-1.
CLUTCH ASSEMBLY MAINTENANCE (SERIAL NUMBERS 235786-235999) (Con’t).
d.
ASSEMBLY
1.
Position clutch disk assembly (4) in place on pressure plate (14) with match-marks alined.
2.
Position three pressure plate springs (15) and remote control levers (16) in place on clutch disk assembly (4) and
pressure plate (14).
3.
With the aid of an assistant, compress pressure plate springs (15) by pushing down on remote control levers (16) and
aline pin holes in clutch disk assembly (4) and remote control levers.
4.
Install three new headed straight pins (17) in clutch disk assembly (4) and remote control levers (16). Peen ends
5.
Using grease and a clean rag, lightly lubricate contact points between pressure plate (14) and clutch disk assembly
(4). Do not to allow grease to contact driving surface of pressure plate.
6.
Position pressure plate (14) and clutch disk assembly (4) in clutch rebuilder.
7.
Assemble three lever screws (18), loop clamps (19), washers (20), and jamnuts (21) partway on pressure plate (14)
and clutch disk assembly (4). Ensure that loop clamps are in position on remote control levers (16) and between
jamnuts and washers, then tighten lever screws and jamnuts.
8.
Remove pressure plate (14) and clutch disk assembly (4) from clutch rebuilder.
TA701307
4-6
|
