|
| |
TM 5-2420-222-20-3
JAW DIRECT LINEAR VALVE (SERIAL NUMBERS 319995 THRU 342573 ONLY) - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
26.
Valve (1)
Two bulkhead
Screw in and tighten to relative
elbows (2 and 3)
positions noted during disassembly using
with attached parts
13/16-inch open-end wrench.
27.
Valve (1) and
Two nuts
Using 13/16-inch and 7/8-inch open-end
two bulkhead
(4 and 5)
wrenches, tighten until seated against
elbows (2 and 3)
valve (1).
28.
Connector (6)
New packing (7)
Place in position.
29.
Valve (1)
Connector (6)
Screw in and tighten using 1 1/4-inch
with assembled
open-end wrench.
packing (7)
30.
Connector (8)
New packing (9)
Place in position.
31.
Valve (1)
Connector (8)
a.
Screw in and tighten using 1 1/2-inch
with assembled
open-end wrench.
packing (9)
b.
Take valve (1) out of machinist’s vise
with vise jaw caps.
32.
Valve
Jaw control
Install (page 2-1391).
(direct linar)
valve tubes
and fittings
INSTALLATION
NOTE
Before installing valve, make sure hoses and tees are in same relative position as noted
during removal.
33.
Link (10) and
Valve (1)
a.
Aline link (10) with hole in valve
bracket (11)
plunger.
b.
Place in position.
34.
Valve (1) and
Two screws (12), new
Screw together and tighten using 9/16-
bracket (11)
lockwashers (13),
inch, 3/8-inch drive deep socket, ratchet
and nuts (14)
handle, and 9/16-inch combination box and
open-end wrench.
2-1256
|
