|
| |
TM 5-2420-222-20-3
LOADER BUCKET CYLINDERS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION- CONTINUED
WARNING
Some parts are heavy. Be careful when handling them. Lifting equipment is needed
when parts weigh over 50 pounds (23 kg) for a single person lift, over 100 pounds
(45 kg) for a two person lift, and over 150 pounds (68 kg) for a three or more person
lift. Do not try to handle heavy parts without lifting equipment. Keep clear of heavy
parts supported only by lifting equipment. Failure to observe this precaution could
cause serious injury or death of personnel.
33.
Loader side
Loader bucket
Take off 200-pound capacity lifting
frame (1)
cylinder (2)
equipment.
34.
Adapter (3)
Line (4)
a.
Take off tag.
b.
Uncap.
c.
Screw in and tighten using 7/8-inch
and 1-inch open-end wrenches.
35.
Adapter (5)
Line (6)
a.
Take off tag.
b.
Uncap.
c.
Screw in and tighten using 7/8-inch
and 1-inch open-end wrenches.
36.
Loader bucket
Two clamps (7)
a.
Place into position as noted during
cylinder (2)
removal.
and two lines
b.
Screw in and tighten using 1/4-inch
(4 and 6)
flat-tip screwdriver.
37.
Loader
Transmission
Check fluid level and add proper amount
backhoe
and grade (TM 5-2420-222-10).
38.
Engine
Start and run at high idle
(TM 5-2420-222-10).
39.
Loader bucket
a.
Operate loader bucket
cylinder (1), two
(TM 5-2420-222-10) and check for leaks.
adapters (3 and 5),
b.
If leaking at any connection, tighten
and lines (4 and 6)
using 7/8-inch and 1-inch open-end
wrenches.
c.
If leaking does not stop, shut down
engine (TM 5-2420-222-10) and
replace leaking connection packing
as outlined in this task.
d.
If found leaking, repeat steps 37
thru 39.
2-1768
|
