|
| |
TM 5-2420-222-20-3
HYDRAULIC PUMP-TO-PRESSURE CONTROL VALVE OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
42
Continued
Hydraulic pump-to-
c
If leaking does not stop, shut down
pressure control
engine (TM 5-2420-222-10) and
valve oil line
replace defective packing, fitting, or
oil line as outlined in this task.
d
If found leaking, repeat steps 40
thru 42.
43
Engine
If still running, shut down
(TM 5-2420-222-10).
NOTE
FOLLOW-ON MAINTENANCE: Install right side grille (TM 5-2420-222-10).
TASK ENDS HERE
HYDRAULIC PUMP PRESSURE LINE TEE-TO-HYDRAULIC ACCUMULATOR OIL LINE
This task covers:
a.
Removal (page 2-1385)
c.
Inspection/Replacement (page 2-1388)
b.
Cleaning (page 2-1386)
d.
Installation (page 2-1388)
INITIAL SETUP
Tools
Materials/Parts
Knife, pocket
Detergent, GP (item 7, Appendix C)
Pan, drain
Lockwasher, accumulator bracket screw
Wrench, box, 9/16-inch
Packing, accumulator tee
Wrench, open-end, 3/4-inch
Rags, wiping (item 21, Appendix C)
Wrench, open-end, 7/8-inch
Solvent, drycleaning (item 28, Appendix C)
Tags, marking (item 30, Appendix C)
NOTE
Personnel Required
The following tool only applies
to loader backhoes with Serial
One
Numbers 235786 thru 235999.
Equipment Condition
Wrench, open-end
Hydraulic system pressure released
(page 2-1191)
2-1384
|
