|
| |
TM 5-2420-222-20-3
CLUTCH CONTROL VALVE-TO-HYDRAULIC PUMP INLET OIL LINE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
INSTALLATION - CONTINUED
38. Loader backhoe
Radiator
Install (page 2-371).
Do not install right side grille at this time.
39.
Transmission
Check fluid level and add proper amount
and grade (TM 5-2420-222-10).
40. Loader backhoe
Engine
Start and run at high idle (TM 5-2420-222-10).
41.
Clutch control
a.
Check for leaks.
valve-to-hydraulic
b.
If leaking at any connection, tighten
pump inlet oil line
using 9/16-inch box wrench, 1 1/2-inch
open-end wrench, and 1/4-inch flat-
tip screwdriver.
c.
If leaking does not stop, shut down
engine (TM 5-2420-222-10) and
replace leaking connection packing,
hose, oil line, or fitting as
outlined in this task.
d.
If found leaking, repeat steps 39 thru 41.
42.
Engine
If still running, shut down (TM 5-2420-222-10).
NOTE
FOLLOW-ON MAINTENANCE: Install right side grille (TM 5-2420-222-10).
TASK ENDS HERE
2-1360
|
