|
| |
TM 5-2420-222-20-2
LEFT OUTER PLATFORM RAMP - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY
NOTE
Step 11 only applies to loader backhoes with Serial Numbers 319995 thru 342573.
11. Ramp (1)
Pads (2, 3, and 4)
a.
If removed, apply metal adhesive in
0.06 to 0.18-inch (1.52 to 4.57 mm)
wide beads, in 2.00-inch (50.8 mm) or
smaller squares.
Make sure that outside bead is within
0.25-inch (6.35 mm) of edge with no
gaps.
b.
Line up and press into place to transfer
some metal adhesive.
c.
Take off and allow metal adhesive to
set for two minutes.
d.
Line up and press firmly into place.
INSTALLATION
12. Front cross member
Ramp (1) with
Place in position.
(5) and center plat-
assembled pads
form support (6)
(2, 3, and 4)
if present
2-1077
|
