|
| |
TM 5-2420-222-20-2
STABILIZERS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
7.
Main frame
Two cotter pins (3)
a.
Using multiple tongue and groove slip-
stabilizer pin (1)
joint pliers, straighten ends.
and washers (2)
b.
Using 2-pound head ball-peen hammer
and 1/2-inch cold chisel, drive out.
c.
Get rid of.
8.
Main frame
Two washers (2)
Take off.
stabilizer pin (1)
and stabilizer (4)
9.
Main frame (5)
Main frame
Using 3-pound head cross-peen hammer
and stabilizer (4)
stabilizer pin (1)
and 3/4-inch brass-tipped driftpin,
drive out.
10.
Stabilizer (4)
a.
Have assistant lift cylinder rod end
with assembled parts
(6) from stabilizer (4).
b.
Using 10-ton capacity hydraulic dolly-
type jack, lower and move out from
underneath.
c.
Have assistant set down cylinder rod
end (6).
d.
With help of assistant, using 10-ton
capacity hydraulic dolly-type jack,
place on wood blocks.
DISASSEMBLY
11.
Stabilizer foot
Two cotter pins (9)
a.
Using multiple tongue and groove slip-
pivot pin (7)
joint pliers, straighten ends.
and washers (8)
b.
Using 2-pound head ball-peen hammer
and 1/2-inch cold chisel, drive out.
c.
Get rid of.
12.
Stabilizer foot
Two washers (8)
Take off.
(10) and stabilizer
foot pivot pin (7)
2-1052
|
