|
| |
TM 5-2420-222-20-2
COWL - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY - CONTINUED
CAUTION
Cowl bumpers, decals, and identification plates may be destroyed during removal.
Do not remove bumpers, decals, or identification plates unless inspection shows
need for replacement.
31.
Cowl (1)
Decals and
Remove (page 2-1186).
instruction labels
32.
Identification and
Remove (page 2-1182).
name plates
WARNING
Water soluble cleaning compound solvent is flammable and fumes are toxic.
Flashpoint is 220°F (104°C). Boiling point is 212°F (100°C). Do not store in
temperatures above 150°F (65°C) or below 35°F (2°C). Do not use near open flame
or excessive heat. Do not wear jewelry, wear rubber gloves and goggles, and use
only in well ventilated area. Avoid contact with skin, eyes, and clothes, and don't
breathe vapors. Avoid contact with acids, aluminum, or zinc; chemical reaction
may result. If you become dizzy while using cleaning compound solvent, get fresh
air immediately and get medical aid. If contact with eyes is made, wash your eyes
with water and get medical aid immediately.
33.
Upper bumper (2) and
a.
Note position for proper placement
cowl bumper (3)
during installation.
b.
Using clean rags and cleaning com-
pound solvent, dissolve adhesive.
c.
Using putty knife under edge, pull
up corner.
d.
Wet with more cleaning compound
solvent and continue to pull off.
e.
Repeat steps b thru d above until
completely removed.
f.
Using clean rag dampened with clean-
ing compound solvent, remove all
adhesive from cowl (1).
g.
Rinse cowl (1), upper bumper (2), and
lower bumper (3) with clean water.
h.
Using clean, dry rags, wipe dry.
2-1012
|
