|
| |
TM 5-2420-222-20-2
TIE ROD - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
50.
Continued
c.
Using 1/2 to 1 1/2-inch adjustable
pipe wrench, turn until slot is facing
to the rear.
d.
Repeat step 48b and 50 as needed until
difference in distance measured in step
48b is correct.
NOTE
If measurement in step 48b is correct and tie rod assembly was not disassembled, skip steps 51 and 52.
51.
Tube (5)
Two clamps (6),
Using 112- to 1 1/2-inch adjustable pipe
screws (7), and
wrench and 3-pound cross-peen hammer,
nuts (8)
tap clamps (6) until openings are pointing
down and screws (7) are horizontal.
52.
Tube (5) and
Two screws (7)
a.
On loader backhoes with Serial
two clamps (6)
nuts (8)
Numbers 235786 thru 235999, using
11/16-inch, 1/2-inch drive socket,
ratchet handle, and 5/8-inch box
wrench, tighten until snug.
b.
On loader backhoes with Serial
Numbers 235786 thru 235999, using
11/16-inch, 1/2-inch drive socket,
0 to 150 foot-pound capacity torque
wrench, tighten to 40 foot-pounds
(54 N.m) torque.
TA243177
2-939
|
