|
| |
TM 5-2420-222-20-2
PARKING BRAKE LEVER AND LINKAGE - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
51.
Brake lever
Washer (3)
Slide on.
support (1) and
brake lever (2)
52.
Brake lever support
Snapring (4)
a.
Using retaining ring pliers, place in
(1) and washer (3)
position.
b.
Take brake lever support (1) out of
machinist’s vise.
INSTALLATION
NOTE
Steps 53 and 54 only apply to loader backhoes with Serial Numbers 235786 thru 235999.
53.
Transmission top
Stud (6)
Screw in and tighten using 1/2-inch drive
cover (5)
stud remover and setter and ratchet handle.
54.
Stud (6)
New locknut (7)
Screw on all the way using xx-inch open-
end wrench.
55.
Right axle housing
Brake lever
Place in position.
(8) and stud (6)
support (1) with
with locknut (7),
attached parts
if present
56.
Brake lever support
Two screws (9),
Screw in and tighten using 3/4-inch, 1/2-
(1) and right axle
washers (10), and
inch drive socket and ratchet handle.
housing (8)
washers (11)
57.
Stud (6) and brake
New locknut (12)
Only on loader backhoes with Serial
lever support (1)
Numbers 235786 thru 235999, screw on and
tighten using xx-inch, 1/2-inch drive
socket and ratchet handle and xx-inch
open-end wrench.
NOTE
Steps 58 thru 60 only apply to loader backhoes with Serial Numbers 319995 thru 342573.
58.
Transmission top
Support (14)
Place in position.
cover (13) and
brake lever
support (1)
2-864
|
