|
| |
TM 5-2420-222-20-2
SPEED GEAR ASSEMBLY (REVERSER) CONTROL LEVER - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
DISASSEMBLY
10.
Lever (1) and
Spring pin (3)
a.
Put lever (1) in machinist’s vise.
washer (2)
b.
Using 1-pound head ball-peen hammer
and 5/32-inch straight drive-pin
punch, drive out.
11.
Lever(1)
Special washer (4),
a.
Slide off.
spring (5), and
b.
Take lever (1) out of machinist’s vise.
washer (2)
12.
Knob (6)
Twist off.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
WARNING
Drycleaning solvent P-D-680 is toxic and flammable. Wear protective goggles and gloves and use only in
a well ventilated area. Avoid contact with skin, eyes, and clothes and don’t breathe vapors. Do not use
near open flame or excessive heat. The flashpoint is 100°F to 138°F (380 to 590C). If you become dizzy
while using cleaning solvent, get fresh air immediately and get medical aid. If contact with eyes is made,
wash your eyes with water and get medical aid immediately.
CAUTION
Do not allow knob to contact drycleaning solvent. Solvent may damage plastic and rubber parts.
13.
Knob (6)
Lever (1)
a.
Using clean, dry rag dampened in dry-
cleaning solvent, wipe clean.
b.
Using clean, dry rag, wipe dry.
14.
All other metal
a.
Clean in drycleaning solvent.
parts
b.
Using clean, dry rags, wipe dry.
2-830
|
