|
| |
TM 5-2420-222-20-2
FRONT LIGHTS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
ASSEMBLY - CONTINUED
24. Terminal (1) and
Screw (3)
Screw in and tighten using 3/16-inch
terminal (2)
flat-tip screwdriver.
25. Terminal (4)
Terminal (5)
Put in place.
26. Terminal (4) and
Screw (6)
Screw in and tighten using 3/16-inch
terminal (5)
flat-tip screwdriver.
27. Front light (7)
Bezel (8) with
a.
Aline tabs in bezel (1) with notches
assembled lamp (9)
in flange.
b.
Work over flange into place.
INSTALLATION
28. Light bracket (10)
Front light (7)
Put in place.
with assembled parts
NOTE
Step 29 only applies to loader backhoes with Serial Numbers 319995 thru 342573.
29. Front light (7) and
New lockwasher (11)
Screw on until snug.
light bracket (10)
and nut (12)
Front light must be free enough to
adjust but tight enough to hold
position.
NOTE
Step 30 only applies to loader backhoes with Serial Numbers 235786 thru 235999.
30. Front light (7) and
Washer (13) and
Screw on until snug.
light bracket (10)
nut (12)
Front light must be free enough to
adjust but tight enough to hold
position.
31. Side frame (14)
Lead (15)
Routing as noted during removal, put
in place.
32. Side frame (14)
Two grommets (16)
Push into place.
and lead (15)
33. Connector (17)
Connector (18)
a.
Plug in.
b.
Take off tags.
34. Loader backhoe
Battery ground cable
Connect (page 2-696).
2-654
|
