|
| |
TM 5-2420-222-20-2
COMBINATION TAIL AND STOPLIGHTS - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REMOVAL - CONTINUED
1.
Taillight (1)
Boot (3)
Pull off.
and plug (2)
2.
Taillight (1)
Plug (2) and
Push in and turn one-quarter turn clockwise
assembled boot (3)
and pull out.
3.
Taillight (1)
Two nuts (5) and
a.
Using 7/16-inch, 3/8-inch drive deep
and fender (4)
lockwashers (6)
socket and ratchet handle, unscrew
and take off.
b.
Get rid of lockwashers (6).
4.
Fender (4)
Taillight (1)
Take off.
DISASSEMBLY
NOTE
It is not necessary to remove combination tail and stoplight to disassemble it.
5.
Lens (7) and
Two screws (8)
Using number 2 cross-tip screwdriver,
taillight (1)
unscrew and take out.
6.
Taillight (1)
Lens (7) and
Take off.
gasket (9)
Do not get rid of gasket unless
inspection shows need for
replacement.
7.
Lamp (10)
Push in, turn one-quarter turn counter-
clockwise and take out.
CLEANING
NOTE
For more information on how to clean parts, go to General Maintenance Instructions (page 2-137).
8.
All plastic and
a.
Clean in solution of detergent and water.
rubber parts
b.
Rinse in clean water.
c.
Using clean, dry rags, wipe dry.
2-634
|
