BOTH COMBINATION TAIL AND FLOODLIGHT FLOODLIGHTS DO NOT WORK

TM 5-2420-222-20-1

ORGANIZATIONAL TROUBLESHOOTING - CONTINUED

MALFUNCTION

TEST OR INSPECTION

CORRECTIVE ACTION

If ground terminal (8) is loose, solder using rosin core solder (item 26, Appendix C), long

round-nose pliers and soldering iron. Assemble combination tail and floodlight (page

2638). Plug terminal (1) into connector (2).

8. BOTH COMBINATION TAIL AND FLOODLIGHT FLOODLIGHTS DO NOT WORK

WARNING

Although ignition lock switch must be on and battery ground cable connected to test electrical circuit

voltage, turn off ignition lock switch and disconnect battery ground cable before doing resistance tests or

replacing parts. This will keep you from getting shocked and prevent damage to parts and equipment.

Check floodlight and front light operation (TM 5-2420-222-10).

If front lights worked during check, repair blue wire in rear light wiring harness (page 2-

137).

If front lights did not work during check, replace light switch (page 2-589).

TA242741

2-71