 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-241O-237-34
3-17. FLYWHEEL HOUSING - REPLACE/REPAIR (Cont'd)
b. Disassemble
(1) Remove rear accessory drive gear
cover assembly. See page 3-126.
(2) Remove rear accessory drive
gears. See page 3-124.
(3) Use a wrench to remove four
capscrews (9) and washers (10)
from each side of the flywheel
housing (6) and remove two
brackets (11).
(4) Use a wrench to remove plug (12).
(5) Use a wrench to remove plug (13).
(6) Use a wrench to remove four
capscrews (14), cover (15) and
gasket (16). Discard gasket
(16).
(7) Remove two washers (17) and pins
(18).
(8) Use a bearing puller to remove
two bearings (19).
(9) If necessary, remove dowels (20
and 21) and stud (22) from
flywheel housing (6).
c. Assembly
(1) If removed, install dowels (20
and 21) and stud (22) into
housing (6). Tighten studs to
35-45 lb. ft.
(2) Use a suitable driving tool to
install two bearings (19).
(3) Install two washers (17) and pins
(18) .
(4) Use a wrench to install four
capscrews (14), cover (15) and
gasket (16).
3-74
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals