 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM5-2410-237-34
3-10. CRANKSHAFT ASSEMBLY - REPAIR/REPLACE (Cont'd)
b. Disassembly
(1) Remove and discard front seal
(13) and wear sleeve (14) from
crankshaft (10).
(2) Use a suitable gear puller to
remove the crankshaft gear (15)
from the crankshaft (10). Remove
key (16) from shaft. DO NOT
REMOVE any of the six plugs (17)
at this time.
(3) Remove and discard rear seal and
wear sleeve (18) as a unit from
the crankshaft (10).
c. Cleaning
WARNING
Compressed air used for cleaning
purposes will not exceed 30 psi.
Use only with effective chip
guarding and personal protective
equipment.
(1) Clean the outside of the
crankshaft with an approved
cleaning solvent (See page 2-29)
and dry thoroughly with low
pressure air (30 psi or less).
CAUTION
If the crankshaft is not to be
inspected immediately (less than
one hour after it is cleaned),
lubricating oil must be put on
the bearing journals to prevent
corrosion.
(2) Put lubricating oil on the
bearing journals if crankshaft is
not going to be inspected within
one hour after cleaning.
3-45
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals