 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
WINCH ASSEMBLY REPAIR - CONTINUED
0245 19
DISASSEMBLY - CONTINUED
WARNING
Wear eye protection when disassembling clutch assembly. Capscrews on clutch plate are under spring ten-
sion. Remove each capscrew a little at a time, in rotation. Failure to follow this warning may result in injury
to personnel.
NOTE
There are two clutch assemblies on clutch shaft. The following steps (steps o through ah) describe and illus-
trate disassembly of one clutch assembly.
o.
Remove eight bolts (175), then use forcing screws to remove plate (176).
p.
Mark position of hub and plates (177) to ensure correct assembly.
q.
Remove six of eight capscrews (178) and plates (177).
r.
Remove remaining two capscrews (178) slowly, so clutch springs (179 and 180) release evenly, and remove mani-
fold (181).
s.
Remove O-rings (182 and 183) from manifold (181). Discard O-rings.
t.
Remove clutch springs (179 and 180). Discard springs.
u.
Remove hub assembly (184).
v.
Remove two O-rings (185) and ball bearings (186) from clutch shaft (155). Discard O-rings.
w.
Remove hub (187).
x.
Remove two bolts (188) and manifold (189).
y.
Remove five clutch discs (190) and four clutch plates (191). Discard clutch discs.
z.
Remove reaction plate (192).
aa.
Remove washers (193 and 194) and thrust bearing (195).
ab. Remove clutch housing (196) from clutch shaft (155).
ac.
Remove bearing spacers (197) and bearing sleeves (198).
ad. Remove nine capscrews (199) and bevel gear (200) from clutch housing (196).
Change 1
0245 19-18
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals