CLEANING AND INSPECTION - TM-5-2410-237-231495

TM 5-2410-237-23

TRANSMISSION OIL PUMP REPAIR - CONTINUED

0245 18

CLEANING AND INSPECTION

WARNING

Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low toxic

material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in

well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to follow this

warning may cause injury or death.

Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure

when drying parts with compressed air. DO NOT direct compressed air against human skin. Failure to

follow this warning may result in injury. Make sure air stream is directed away from user and other

personnel in the area. To prevent injury, user must wear protective goggles or face shield.

Clean all parts in solvent cleaning compound.

Thoroughly dry all parts with compressed air.

Inspect parts for nicks, burrs, cracks, pitting, breaks, distortion or other damage IAW WP 0241 00.

Measure inside diameter of bearing sleeves. Dimension should be 1.2514 0.0003 in. (31.786 0.008 mm).

Measure diameter of driven and drive gear shafts. Diameter should be 1.2497 0.0002 in. (31.742 0.005 mm).

Measure clearance between driven and drive gears and cover. Clearance should be 0.0022 0.0003 in. (0.056 0.008

mm).

Replace damaged or defective parts.

0245 18-3

Change 1