 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 5-2410-237-23
TRANSMISSION ASSEMBLY REPAIR - CONTINUED
0245 15
CLEANING
WARNING
Dry cleaning solvent MIL-PRF-680 Type III is an environmentally compliant and low toxic mate-
rial. However, it may be irritating to eyes and skin. use of protective gloves and goggles is sug-
gested. Use in well-ventilated areas. Keep away from open flames and or sources of ignition.
Failure to follow this warning may cause injury or death.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Failure to
follow this warning may result in injury. Make sure air stream is directed away from user and or per-
sonnel in area. To prevent injury, user must wear protective goggles or face shield.
1.
Remove gasket material from all mating surfaces.
2.
Clean all parts with solvent.
3.
Dry all parts with compressed air.
INSPECTION
NOTE
Replace all parts that are damaged or not within specifications.
1.
Inspect all parts for visible signs of wear or damage and replace as necessary.
2.
Measure thickness of two discs and one plate for No. 3, No. 4 and No. 5 clutches. Thickness should be 0.688 0.009 in.
(17.47 0.24 mm). Do not use parts that are out of specification:
a.
Plate thickness should be 0.250 0.003 in. (6.35 0.08 mm).
b.
Each disc thickness should be 0.219 0.003 in. (5.56 0.08 mm).
3.
Measure thickness of four discs and three plates for No. 1 clutch. Thickness should be 1.626 0.021 in. (41.31 0.54
mm). Do not use parts that are out of specification:
a.
Each plate thickness should be 0.250 0.003 in. (6.35 0.08 mm).
b.
Each disc thickness should be 0.219 0.003 in. (5.56 0.08 mm).
4.
Measure thickness of three discs and two plates for No. 2 clutch. Thickness should be 1.157 0.016 in. (29.38 0.40
mm). Do not use parts that are out of specification:
a.
Each plate thickness should be 0.250 0.003 in. (6.35 0.08 mm).
b.
Each disc thickness should be 0.219 0.003 in. (5.56 0.08 mm).
0245 15-21
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals